Vertical Square Sedimentation Tanks
The plane of the sedimentation tank is rectangular, and the inlet is set at the end of the tank. Generally, the swallowing water inlet is used. The water flows from the inlet to the tank through the uniformly distributed inlet holes.
Send InquiryIntroduction
The plane of the sedimentation tank is rectangular, and the inlet is set at the end of the tank. Generally, the swallowing water inlet is used. The water flows from the inlet to the tank through the uniformly distributed inlet holes. A baffle is provided behind the inlet to make the water flow uniform. The ground is distributed across the width of the pool. The outlet of the sedimentation tank is set at the end of another wastewater sedimentation tank of the tank. An overflow weir is usually used to ensure that the clear water after the deposition can flow into the drainage channel uniformly along the width of the tank. A scum tank and a baffle are set in front of the weir to intercept scum on the water surface. The water part is the main body of the pool. The width and depth of the pool should ensure that the water flow is evenly distributed along the cross section of the pool, and the flow velocity is passed slowly and steadily according to the plan. The length-width ratio of the pool is generally not less than 4, and the water depth of the pool is generally not more than 3 meters. The sludge bucket is used to accumulate the deposited sludge, and it is mostly located below the bottom of the pool in the front of the pool.
Product detail
Original: Jiangsu, China
Certification: ISO9001, ISO14001, etc.
Price: Negotiable
Material: SUS304/SUS316L/Q235
Voltage: 380V 50Hz, the voltage can be as local demand
Payment term: TT, LC
Delivery date: Negotiable
Packing: export standard
Market: Middle East/ Africa/Asia/South America/Europe/North America
Warranty: 1 year
MOQ: 1 set
Equipment characteristics
In order to avoid short flow, the first is to try to adopt some methods in the plan (such as selecting a suitable water distribution device to eliminate the inlet jet, so that the water flow is evenly distributed on the cross section of the sedimentation tank, reducing turbulence and preventing sludge areas. Adjacent flow velocity is too large. Use finger-shaped water tanks to extend the length of the weir. Settling ponds should be covered or partition walls should be installed to reduce the impact of wind and sunlight. Heterogeneous flow due to high suspended solids concentration, etc.); Second, strengthen operation management. Before putting the sedimentation tank into operation, you should strictly check whether the outflow weir is straight, and if any problem is found, repair it in time. During operation, dross may block part of the overflow weir, causing the entire outflow weir to have a different unit length of overflow and suction of water flow. The operator should timely clean up the dross on the weir; the sawtooth triangular weir made of plastic Due to the time relationship, the deformation may occur, and the management personnel should repair or replace it in time to ensure the uniform flow and reduce short flow. By adopting the above method, the short-flow phenomenon of the sedimentation tank can be reduced to a minimum.
Hot Tags: vertical square sedimentation tanks, China, suppliers, manufacturers, factory, customized, price, OEM
