The rubber diaphragm in the tube aerator is made of EPDM rubber, which has the characteristics of heat resistance, ozone resistance, acid and alkali resistance, good chemical stability, etc. The aeration hole is a long hole with a shape, which makes it have good properties. Tensile and instantaneous closure, microbubbles with a diameter of less than 3mm can be released during aeration; in general, the support tube is made of ABS.

The air pipe of the tubular aerator is made of engineering plastic ABS material, which adopts hollow and water-filled form, which greatly reduces the buoyancy of the aeration system in water. Due to the special nature of the material, the tube aerator is also stored when it is stored. All the accessories in the aerator and the original packaging should be stored in a dry and ventilated room as required.

Prevent contamination from freezing, overheating, direct sunlight, dust, mineral oil and hydrocarbons; do not install the tube aerator close to the engine storage, especially the blower; avoid any damage to the aerator and its packaging. All aerators and accessories must be kept in their original packaging when stored on site. When the carton is directly exposed to the sun, apply an oiled tarpaulin; packaging materials containing plasticizers should not be used.www.khnwatertreatment.com