The working efficiency improvement method of shallow air flotation device
Aug 02,2021
Shallow air flotation is a common waste water treatment equipment. When machinery and equipment are working, they mainly remove transparent liquid in sewage. In application, in order to better ensure that machinery and equipment are working for everyone, they need to be used. Appropriate methods of operation can improve the working efficiency of machinery and equipment. So, how to improve the working efficiency of shallow air flotation?
1. Before applying the shallow air flotation equipment, you need to check the switch power supply line of the equipment and do a short full-load operation. In order to distinguish whether the conversion of the pump and the air compressor is appropriate, whether there is noise and heat, the mixer is introducing cold water Jog when the device is switched to distinguish whether the conversion is appropriate.
2. When we use machinery and equipment, we also need to pay special attention to the sludge collection and speed reduction machine of the machinery and equipment to observe whether the rotation is appropriate, whether there is impact or instability, immediately clear it, and open the dissolving medicine machine. The power switch is configured according to the concentration value of the chemical solution. Stir until the concentration value of the chemical solution is uniform, clean the air flotation machine without leaving dirt, check whether the connection position is loose, and the introduction of grease at the rotating position.
3. Everyone needs to remove the sludge from the slag scraper on time, and establish realistic slag scraping rules and regulations. The air flotation machine needs to have the ability to decontaminate when in use, so that you can know how much total area can be solved when you use it. . It should be noted that in the whole process of applying shallow air flotation equipment, we also need to ensure that the water level of air flotation does not engulf the filling material layer and is not less than 0.6m. It is to better prevent the middle zone from being a lot. Undissolved gas harms the actual effect.
https://www.khnwatertreatment.com/