1. There is an emergency stop switch on the door of the cabinet. When there is an abnormal common fault, press and hold all the system software to stop running. After confirming that everything is normal, you can rotate the button to calibrate it.

2. The surrounding area of ??the stainless steel mechanical grille should be kept clean , and should be checked and removed at least once a day. Don't put blocks, carpentry boards, and other dirty funds into the grille forebay !

3. Always check whether the skeleton seal of the stainless steel mechanical grille reducer sees oil, and the damaged skeleton seal should be replaced immediately. If the amount of oil is not enough, oil should be supplied immediately and replaced on time. The reducer should be lubricated, and maintenance should be carried out according to any SEW instructions.

4. Be sure to replace the initial grease 30h during the operation of the high-pressure water pump, and then replace the grease every 100h during the work . Warning: Before changing the oil, be sure to disconnect the isolation switch QF5/QF10 of the high-pressure water pump motor .

5. The machine should be prevented from shutting down for a long time to ensure that the stainless steel mechanical grille machinery and equipment are in good running condition everywhere. When the shutdown exceeds seven days, the waste water must be emptied, and the grille cannot be soaked in the flowing waste water for a long time.

6. The maintenance of electrical equipment should be carried out by technical professional staff, and the switching power supply should be disconnected during maintenance.

https://www.khnwatertreatment.com/