There are two important parts in the tube aerator that connect the hose and the aeration head. Maybe many friends don’t know it well. When using these, sometimes there will be some failures. When there is a failure, we need to go to it in time. Solve, otherwise there will be some more serious problems. Let's first analyze what failures often occur in the aerator hose, and the economical and effective installation method of the tube aerator - aeration tube. Cut the main pipe of the aeration pipe according to the drawing, cut the pipe, determine the position of each casing type aerator, install the diaphragm (this equipment is provided with a complete set of pipe type aerator and diaphragm separately), and install the aeration membrane Pay attention to the installation of some non-porous membranes perpendicular to the ground during the filming, tighten the clamps at both ends of the aerator diaphragm, install the adjustable bracket for the main pipe, and level each main aeration pipe on the same level. After the diaphragm is installed, install the whole set The installation of the tubular aerator is at the same position as the previous opening; (note that the opening position should be on the same plane) After all the pipes are installed, install the aeration standpipe, and finally install the microporous aeration pipe. 　　The variable orifice aeration hose is made of reinforced polyvinyl chloride and rubber. The inside of the hose is lined with chemical fiber mesh, which is acid-resistant, alkali-resistant, corrosion-resistant, colorless, odorless, and non-oily, and overcomes high-pressure strength.　  

https://www.khnwatertreatment.com/